The complete guide
Buying Guide
A roadside kit in one case
A flat tire is never fun, but the right kit makes it quicker. This 12V electric jack kit puts a jack, tire pump and impact wrench in one storage case. It runs from your car's 12V socket or from the battery with clamps.
What is in the case
- 12V electric hydraulic jack with a built-in tire pump and pressure display
- Electric impact wrench
- Safety hammer
- Gloves
- Storage case
- 3.5 m power cable
The kit weighs about 6.8 kg.
How the jack works
The jack is rated to 5 tonnes. It lifts from 15 to 45 cm (5.9 to 17.7 in) using dual motors. You place it under the lift point, connect power and press the button. It is made to lift one wheel at a time.
Changing a wheel, step by step
- Park on firm, level ground away from traffic. Turn on your hazard lights.
- Set the parking brake and chock the wheel opposite the one you are lifting.
- Find the lift point in your owner's manual.
- Loosen the wheel nuts a little with the impact wrench while the tire is still on the ground.
- Place the jack under the lift point and raise the car until the tire is just off the ground.
- Remove the nuts and swap the wheel.
- Lower the car, then tighten the nuts fully. Check them again after a short drive.
Never put any part of your body under a car held only by a jack. For work under the car, use jack stands at the right support points.
Pump up a soft tire
The pump is built into the jack. Connect it to the tire valve and watch the pressure on the display. Stop at the pressure shown on the sticker inside the driver's door or in your manual.
Before you buy
- Check your vehicle weight against the 5 tonne rating.
- Find your lift points and make sure they sit within the 15 to 45 cm range.
- Make sure your car has a working 12V socket, or plan to use the battery clamps.
- Read the manual before the first use, not at the roadside.
Keep the kit in the trunk, so it is there when you need it.



